Firmware Update via SD card
This update provides support for SeaGaugeG4 WIFI Gateways with NMEA 2000 interfaces.
New Supported Functions
- J1939 Alarm Messages via DTC1 0x0FECA (65266)
- SPN 110 FMI 0 - ALARM_MESSAGE_J1939_ENG_TEMP_HIGH
- SPN 100 FMI 0 - ALARM_MESSAGE_J1939_ENG_OIL_LOW
- SPN 100 FMI 1 - ALARM_MESSAGE_J1939_ENG_OIL_HIGH
- SPN 102 FMI 1 - ALARM_MESSAGE_J1939_ENG_BOOST_LOW
- SPN 102 FMI 0 - ALARM_MESSAGE_J1939_ENG_BOOST_HIGH
- SPN 168 FMI 1 - ALARM_MESSAGE_J1939_ENG_VOLT_LOW
- SPN 173 FMI 0 - ALARM_MESSAGE_J1939_ENG_EGT_HIGH
- SPN 190 FMI 0 - ALARM_MESSAGE_J1939_ENG_SPEED_HIGH
- SPN 101 FMI 16 - ALARM_MESSAGE_J1939_ENG_CRANKCASE_HIGH
- SPN 94 FMI 16 - ALARM_MESSAGE_J1939_ENG_FUELFLOW_LOW
- SPN 177 FMI 0 - ALARM_MESSAGE_J1939_TRAN_TEMP_HIGH
- SPN 177 FMI 1 - ALARM_MESSAGE_J1939_TRAN_PRESSSURE_LOW
- Fast CAN BUS updates for NMEA2000/J1939 RPM and Fuel Flow PGN (0.5 sec)
- Updated J1939 sensor calibration files
- Increased CAN bus update interval for PGN127488 to 0.25 sec
- added defaults for pulse intervals
This update contains one firmware.bin and two spiffs.bin files (www & calibrations)
The complete update requires 3 steps for each file.
1) Unzip file and copy to specified folders in root of SD card
2) Repower SeaGaugeG4 Gateway and wait for SeaGaugeG4-XXXX device to show in WIFI networks list
3) Connect to Gateway via WIFI ADHOC SeaGaugeG4-XXXX and verify the new firmware version in config page is 1.9.3.25.22
